Shop
Showing 1825–1848 of 1946 results
-
Electronic Switches/Keypad
TTP229 16-Way Capacitive Touch Switch Digital keypad Module
Ask for latest offers/availability : https://bit.ly/2LHBUZa
- Working voltage: 2.4V to 5.5V
- Built-in regulator
- Two modes
- Simple 8 key mode with independent 8 Channel parallel output.
- Advanced 16 Key modes with I2C interface output.
- Modes can be selected and configured by the user.
- Adjustable sensitivity
SKU: n/a -
Sensors
Tube Type Inductive Proximity Sensor Detection Switch NPN DC6-36V 4mm Normally Open switch LJ12A3-4-Z/BX
SensorsTube Type Inductive Proximity Sensor Detection Switch NPN DC6-36V 4mm Normally Open switch LJ12A3-4-Z/BX
Ask for Latest offers/availability : https://bit.ly/3BcmrZj
- Output Type: NPN-NO
- Red LED checks the state of the proximity sensor
- High repeated positioning accuracy
- High switching frequency
- Wide voltage range
- Antivibration, dust, water and oil prevention
- Reverse power protection, short circuit protection, directly connecting with PLC
- Can replace small switches and limit switches
SKU: PGI-0043801 -
Water Flow And Level Sensor
Turbidity Sensor with Module
Ask for latest offers/availability : https://bit.ly/2KEltMw
- Operating Voltage: 5VDC.
- Current: 30mA (MAX).
- Operating temperature: -30 ° C to 80 ° C.
- Compatible with Arduino, Raspberry Pi, AVR, PIC, etc.
- Measuring Range: 0 ~ 1000 NTU.
SKU: PGI-0062828 -
-
Camera
TVL 90 degree CMOS Camera
Ask for Latest offer / Availability : https://bit.ly/37mwKMf
- Working voltage range: 4.5V-6V DC.
- Angle: 90 degrees.
- Horizontal Resolution: 1000TVL.
- Image Sensor: 1/3″ CMOS.
- Pixels: 1280 x 720.
- Minimum Illumination: 0.05LUX/F1.2.
- White Balance: Automatic.
- Gain: Automatic.
- Digital Noise Reduction: Yes (2D).
- Gamma Correction: 0.45.
- S/N Ratio: ≥50dB.
SKU: PGI-0045649 -
Flight Controller & Accessories
UBEC-5V/3A
Ask for Latest offers/availability : https://bit.ly/2XJxIS9
- Working voltage: 5.5v-35v lipo 2s-5s
- Continuous current: 3A
- Instantaneous current: Min. 4A 20 seconds
- Output voltage: 5.25V +/-0.5V
- Suitable for: RC AirPlane Multirotor helicopter
- Special for FPV image transmission
SKU: PGI-00974848 -
-
Gsm/Gprs
Ublox NEO-M8N GPS with Compass for Pixhawk with extra connector for APM
Ask for Latest offer / Availability : https://bit.ly/33oihPm
- Ready to Connect to PIXHAWK FC with 6-pin connector Attached
- Receiver type 72-channel Ublox M8 engine
- Galileo-ready E1B/C (NEO-M8N)
- Nav. update rate1 Single GNSS: up to 18 HZ
- Acquisition Cold starts: 26 s
- Onboard Compass
SKU: PGI-57286 -
-
-
Development Board
UDOO Neo Development Board (Extended)
Ask for Latest offer / Availability :https://bit.ly/3cQRNZV
- NX i.MX 6SoloX applications processor with an embedded ARM Cortex-A9 core and a Cortex-M4 Core
- Integrated 2D/3D graphics controller
- Micro HDMI interface – LVDS interface + touch (I2C signals)
- Analog camera connection supporting NTSC and PAL – 8-bit parallel camera interface
- MicroSD card slot onboard – 8-bit SDIO interface
- HDMI audio transmitter – S/PIDF & I2S
- 1x USB 2.0 Type A ports – 1x USB OTG (micro-AB connector)
- Wi-Fi 802.11 b/g/n, Direct Mode SmartConfig and Bluetooth 4.0 Low Energy
SKU: PGI-00202893 -
Development Board
UDOO X86 Advanced Plus Single Board Computer/Development Board
Ask for Latest offers/availability : https://bit.ly/3ll8Auk
- Full-fledged PC + Arduino 101
- Open Source Hardware
- Open Source Software
- Growing community
- Huge compatibility: Arduino™ 101, Open Source and x86 worlds
- Any PC-OS or distribution
- Any computer language
- No delays for kernel’s porting or stuck to old kernels
- Boot from everywhere
SKU: PGI-00199519 -
-
-
-
Robocon
Ultrasonic Intelligent Bluetooth Robot Car Kit
- The control motor selection L298N drive module, and single-chip microcomputer real isolation.
- The obstacle avoidance of the HC – SR04 ultrasound, stable performance, precise measure distance.
- Can access external 7 ~ 12 V voltage.
- And can carry many sensor modules, according to your imagination to realize various functions.
SKU: n/a -
-
-
-
-
Glue Gun & Sticks
Universal Glue Gun SD-A601 20W with Switch (High Quality)
Ask for Latest offer / Availability : https://bit.ly/36YoFzg
- Voltage: 110-220V
- Power consumption: 20W
- Melt Temperature(°C): 190 (± 10)
- Use Glue Stick Size: 7MM
- The Trigger-freed mechanism controls glue flow
- 20 watts Green Glue Gun with Instruction on the Back Side.
- Thermostat, Speed Melt (Internal PTC Heating Element).
- Hot Melt Glue Gun Solid Body, The use of Advanced Engineering Plastic Manufacturing.
SKU: n/a
